Tips of concrete grinding

2018-07-23

Grinding slowly

Because the Scanmaskin grinding machine has the function of variable speed, sometimes it will lift and skip the surface when running. So, if the machine runs too fast, it will reduce the efficiency of construction. While running at a higher speed, the speed of the ground floor is accelerated, but the results are often uneven in performance, resulting in more rework and lower satisfaction. Slowing down the speed of your variable speed grinding machine can help you finish your homework faster, and the result will be better.

Adding concrete cushion

If you are grinding the concrete floor, you find a lot of sand and machine debris, and the most likely thing is that the concrete base is too thin to grind to the bottom of the concrete. The massive gravel at the bottom of the concrete will wear the expensive diamond grinding machine, which is also very bad for vacuum hoses and filters. Therefore, we need to increase the thickness of the concrete floor cushion before the grinding. It is not only helps to stabilize the concrete floor, make it more dense, but also conducive to the application of tools.

Use the suitable lubricating oil

When using scraper tools on grinding machines or using cemented carbide tools on loosen machines, it is necessary to spray mild lubricants on tools. This process will help to keep the tool cool and reduce the amount of material accumulated on the tool. And, it is very effective for protecting the chassis of the grinding box on the scarf machine. In heavy wet cutting, it will also help prevent mud from sticking on the grinding machine chassis. There is no need to worry that the lubricating oil will be transferred to the floor because the viscosity is not large enough to form stains on the concrete floor.

Avoid use the cleansers

The use of cleaning agent will result in shortening the service life and increasing wastage of the grinding machine. Do not use clean chemicals when cleaning polished floors or coatings. Cleansers are very popular, as dirt and dust are sealed in the oil, and the solid remains dry, making it easier to clean up, but this can damage the machine's functionality. Surface dust is collected in one area of the floor, and foam scrapers are recommended instead of cleaning compounds. Scrapers can be used to shovel dust into trash cans or plastic bags.

Scanmaskin tooling can do all jobs above.

                QuickMark for this article